I don't want to put 4 pieces of metal in the wings
Just a few minutes for each flight, heating up is not an issue for F3F
my 0.02 . .
| RC Slope Soaring in Hong Kong http://rcsail.com/forum/ |
|
| MKS 的無刷馬達伺服機 http://rcsail.com/forum/viewtopic.php?f=2&t=1793 |
Page 1 of 1 |
| Author: | Ah Pong [ Wed Mar 24, 2010 11:25 pm ] |
| Post subject: | MKS 的無刷馬達伺服機 |
Just see this: http://www.efly98.com/cdb_efly98/viewthread.php?tid=95952&extra=page%3D1 |
|
| Author: | CM Cheng [ Thu Mar 25, 2010 12:08 am ] |
| Post subject: | |
I don't want to put 4 pieces of metal in the wings
Just a few minutes for each flight, heating up is not an issue for F3F my 0.02 . .
|
|
| Author: | Ah Pong [ Thu Mar 25, 2010 9:53 am ] |
| Post subject: | |
Hi CM, Not just the metal case, but the material of gear set and BL motor. Worth to try. |
|
| Author: | CM Cheng [ Thu Mar 25, 2010 10:07 am ] |
| Post subject: | |
Read the adv. twice, I don't think the 10mm is BL (see the shape of the motor). I cannot find the information of the 10mm in their web site either. To me, I prefer a stripped gear to a damaged aileron! It is easier to replace a servo than to repair a model in a competition. Plastic gear is cheap too
As you always said, let's wait and see . . . Pong-pong, you are the technical chair of the HKRCSS committee  . How about you test it and give us a report? 
|
|
| Author: | K.Y.Mak [ Thu Mar 25, 2010 3:08 pm ] |
| Post subject: | |
CM Cheng wrote: Read the adv. twice, I don't think the 10mm is BL Read again. The adv. said: "日本進口頂級無刷馬？" CM Cheng wrote: To me, I prefer a stripped gear to a damaged aileron! It is easier to replace a servo than to repair a model in a competition. Plastic gear is cheap too
May be, you want to replace all it's gears with a set from the HS-125  
They'll break as often as you like
|
|
| Author: | CM Cheng [ Thu Mar 25, 2010 3:35 pm ] |
| Post subject: | |
Hi Mak, I think Brushless is refering to the two big servos below
Nevertheless, I believe our technical chair Pong-pong will give it a full review!  邦邦成日唔開會
|
|
| Page 1 of 1 | All times are UTC + 8 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|